Install Guides: Lip Kits

Please note that this is a general installation guide and may not apply to all applications. It is not meant to serve as a substitute for professional expertise. If you are at all confused by any of the information contained in this article, you should seriously reconsider attempting the installation on your own. BodyKits4Cars.com is not able to replace parts that have been damaged as a result of attempted installations pursuant to the information contained within this guide or for any other circumstances.


Installation Guide (Front & Rear Lips)

*NOTE: Due to strict regulations by the Department of Transportation, some of the products sold by BodyKits4Cars.com are aftermarket products and are intended for off-road or show use only.

WARNING: PROFESSIONAL INSTALLATION BY EXPERIENCED AND COMPETENT MECHANIC RECOMMENDED. MAY REQUIRE SPECIAL TOOLS AND/OR SHOP EQUIPMENT.

➀  PLACE FRONT LIP ON CAR AND CHECK THE FITMENT. USING A GREASE PENCIL, DRAW A LINE ALONG THE TOP EDGE OF THE PART FOR REFERENCE ON WHERE THE PART WILL BE INSTALLED. (NOTE: STYLES MAY VARY WHICH MAY RESULT SANDING AND/OR TRIMMING OF SIDESKIRT FOR PROPER FITMENT.)

➁  REMOVE PART AND CLEAN THE SURFACE WHERE THE TAPE WILL COME IN CONTACT WITH THE LIP AND VEHICLE.

➂  APPLY DOUBLE-SIDED TAPE APPROXIMATELY ¼” LOWER THAN THE LINE DRAWN WITH THE GREASE PENCIL (IF APPLICABLE).

➃  PEEL APPROXIMATELY 2” OF PLASTIC BACKING OFF TAPE, MAKING A “TAIL” FROM CENTER OF PART SO THAT YOU CAN POSITION PART ON CAR WITHOUT COMPLETELY REMOVING BACKING FROM TAPE. POSITION PART ON CAR, USING YOUR GREASE LINE AS A REFERENCE. ONCE IN PLACE, PULL “TAIL” AND PRESS FIRMLY.

➄  PRESS FIRMLY TO ENSURE GOOD ADHESION. DRILL (2) 1/8” HOLES INTO EACH WHEEL WELL AND SECURE WITH (2) PHILLIPS HEAD SCREWS PER SIDE.